HOW TO PREP FOR APPLICATION

• Clean any loose dust, dirt, and contaminants from the surface.

• Clay bar any rough embedded contaminants from the surface to ensure no impurities interfere with the properties of the coatings.

• Polish/Compound to remove any paint defects in the form of scratches, swirl marks, and oxidation. 

• Deep clean any polish oils or residues from the surface that could inhibit the bonding process using Ethos Detox.

A LITTLE GOES A LONG WAY

We believe anyone should be able to get showroom quality shine and protection from a Ceramic Coating without the professional application cost. In this spirit, we made a Ceramic Wax that can be applied by anyone with no special knowledge or tools required. Just wipe on Ceramic Wax Pro in a smooth thin even layer panel by panel. When you see the layer turn slightly hazy it's done curing just wipe clean and enjoy your beautifully slick and shiny surface!

HOW TO APPLY

1. Make sure the surface has been completely cleaned and decontaminated with Ethos Detox. The cleaner the surface, the better the bond!

2. Shake bottle well.

3. Apply a few drops of Ceramic Wax Pro onto your applicator until evenly covered.

4. When applying to your car you want to use very thin layers, you should be able to see your paint through your coating, if the application appears white or chalky you're applying too much product.

5. You can apply circular or straight-line motions to your car whichever you feel most comfortable doing. The most important aspect here is to make sure you are getting even coverage.

6. Applicators should glide smoothly on the surface while laying down an even layer of coating. If the applicator starts to drag or the application becomes inconsistent, apply additional Ceramic Wax Pro to the applicator.

7. Once applied to your surface there is an average cure time of 10-15 minutes but that can vary depending on your climate. A good way to test if Ceramic Wax Pro is cured is to wipe one finger along the coating, if the wax removes without any leftover residue it's cured.

8. Using premium microfiber towels (Preferably our Utility Towels), thoroughly wipe down the section to remove the Ceramic Wax Pro residue. Your first wipe should remove about 80% of the residue, and your second wipe should easily remove the remainder. Use small, circular motions and little to no pressure during removal.

9. IMPORTANT: Be sure to check adjacent panels to make sure you haven't "pushed" excess coating to other areas. Be thorough and continue to check your work before moving on to the next step.

10. Let the coating dry / cure for at least 24 hours before allowing it to get wet. The longer it stays dry the better, as it will continue to cure for about 5 days (you CAN drive the car during this time). We recommend that you don't wash the car for about a week afterward.